CANsmart Wiring Harness for T3 Switchback Signals

Use the DENALI wiring adapter for connectingT3sto the GEN II CANsmart Controller for a true plug & play connection.

Compatible with all GEN II DENALI CANsmart Controllers, no wire tapping or other modifications are necessary, just plug directly into the circuits of the CANsmart to sendthe signals from your controller to theT3 Lights. This harness is designed to power a set of four T3 lights; two rear T3s & two front T3s, but can also be configured for an installation of just front or rear T3s as well.

Please note that when powering rear T3s through this plug & play adapter from a CANsmart the red running light will remain illuminated between the amber turn signal flashing. This is an unavoidable resultwhen powering T3ssolely from aCANsmart. If you’d prefer that the running light shuts off when the amber signal is active, simply connect the red running light wires from the T3 pods directly to a switched power source on your vehicle (and set the CANsmart brake light circuit to brake only).

Note:Not compatible with KTM 790 Adventure, 890 Adventure, Husqvarna Norden 901, or Yamaha Tenere 700